This is an 8 gallon 304 stainless steel kettle with drilled holes for the weldless thermometer and weldless ball valve. Both the thermometer and the ball valve come with this item and are both stainless steel. The thermometer has 2" probe. The 2" probe is perferred in the kettle over a 6" probe so as not to be damaged when stiring the kettle with your stainless steel spoon.
THIS KETTLE IS INDUCTION READY if your cook top requires a magnet to heat up!
The face of the thermometer is 3", reads from 0 - 220 degrees F or -10 to 100 degrees C. The thermometer is easily calibrated using a set screw on the back of the dial. To calibrate, boil some water and set the thermometer to 212 degrees F or 100 degrees C. Two high temp silicone washers are included on the thermometer. One is placed on each side of the kettle and secured in place when screwed into place with the lock nut.
The ball valve is a 1/2" stainless valve with a 1/2" barbed outlet. Two high temp washers are included with the valve. Similiar to thermometer, one is placed on each side and held in place with a lock nut. Using two washers helps insure you will have a leak free brew day.
The kettle has a tri clad bottom that will spread the heat of a direct flame from your burner across the bottom and minimize any chances of scorching. Kettles that only have a single layer bottom will likely cause scorching during the boil and will change the flavor of the finished beer. Scorched wort is not as fermentable and leaves a finished beer with a higher gravity and less alcohol.
The kettle handles are rivited into place and sturdy. The lid has nice large handle as well. This kettle is built to last through years of use in your brew house.
False Bottom - The false bottom fits the kettle to its specific diameter and stands up off the bottom above the ball valve but below the thermometer. The false bottom has a large surface area and is effective when used during the boil to help separate the hops, both pellet and leaf, from passing into the ball valve. Alternatively, the false bottom can be used in the kettle so that the kettle becomes a mash tun.
Sight Glass - We can install a weldless sight glass in the kettle. The sight glass is made of stainless steel and allows you to calibrate the kettle to your liking so that you can accurately collect and boil the volume of wort you intend on making.
*COSMETIC DAMAGED, MOST DAMAGED KETTLES HAVE DENTS IN THE BOTTOM SEAM OF THE KETTLE.