Bottle Washer - Hose Thread Adapter

(2 reviews) Write a Review
Bottle Washer - Hose Thread Adapter

This hose adapter is used to convert your sink faucet to the garden hose threads needed for the blast bottle washers or with an immersion coil.  The adapter use the standard dishwasher thread.  Complete with washer. 15/16" - 27 thread male exterior and 13/16" female interior x 3/4" male hose thread.

2 Reviews Hide Reviews Show Reviews

  • 3
    Seal Leaks

    Posted by Unknown on 8th Sep 2015

    The adapter threaded in fine, but even when I tighten is as far as it will go, the connection does not seal, so there is water leaking while I am washing bottles. I had to keep the pressure lower than I would have preferred so that water did not spray all over my kitchen. I was able to use it, and it did connect fine, but may need one more rubber gasket, or thicker ones.

  • 3
    Grommet Fell out

    Posted by Jack on 23rd Dec 2014

    The adapter is well made, however, the grommet that fits between the faucet and adapter itself completely fell out and was too loose to stay in. It ended up going down my sink and I will have to replace it.